Bulk Water Station Technology

New online pre-payment system

A new online pre-payment system and keypad terminal will replace Halton’s Smart Card payment and reader system, starting in late March 2018. To avoid disruption in service, set up an online account or call 311 for more information.

IMPORTANT:

The Nipissing Road coin-operated bulk water station will be permanently closed as of May 31, 2018.

The Technology of a Bulk Water Station

The bulk water dispensing stations in Halton are fully assembled, pre-wired, skid mounted water dispensing systems designed and built by The Birk’s Company. The technology was used and tested at various municipalities across Canada before they were adopted by Halton.

The water dispensing station systems are made up of:

  • A water meter
  • Heater
  • All necessary wiring
  • Solenoid and other valves
  • Stainless steel pipes and fittings
  • NEMA 3R rated load centre on the exterior
  • Smart Card transaction terminal, to be replaced with new keypad and online account pre-payment system in mid-January 2018.
  • Internal bracing, pipe supports and lifting lugs
  • 75mm (3") or 50mm (2") male camlock coupling with a PVC "breakaway" nipple or "drive-away" hose
  • 56" x 45" concrete mounting pad that sits 3" to 10" above the ground
    Power supply - 120 VAC

top of page

Water Flow Control Valves

Each station is equipped with a meter/solenoid valve, which has an integrated flow control function.

The Region's operator adjusts the valve's open/close speed to prevent water hammer. An individual maximum flow rate is set at each station based on the conditions of the area to:

  • Insure accuracy of measurement.
  • Prevent the drawing down of the pressure in the water main, which would be caused by excessively high flow rates.

top of page

Outlet Flow Rates

75mm (3") diameter outlet:

  • min flow = 454 L/min (120 USGPM)
  • max flow = 1817 L/min (480 USPGM)
  • Halton recommended max flow = 1135 L/min (130 USGPM)

50mm (2") diameter outlet:

  • min flow = 110 L/min (29 USGPM)
  • max flow = 416 L/min (110 USGPM)
  • Halton recommended max flow = 378 L/min (100 USGPM)

top of page

Payment and Dispensing System

The current Smart Card payment system will be replaced by a new online pre-payment system in late March 2018. To avoid interruption in service, please set up your online account as soon as possible.

top of page

Calibrating Dispensing Device

Calibration accuracy of the dispensing instruments is an ongoing concern for customers and the Region.

In order to address this concern the construction of Halton's own mobile calibrating device has been proposed. This will allow for more effective and more regular calibration then the current annual method. 

Increased calibration will ensure that we are servicing our customers as effectively as possible, by making sure they are getting what they pay for.

top of page